If your gimbal handle diameter is smaller than 40mm,like 31mm Zhiyun Crane Plus&Crane V2,then you need to insert our round base plate into Ares middle connect bridge clamp,tighten it,and then install gimbal on top of the round base plate via 1/4” screw. World first Z axis alloy spring dual handle for Ronin S,also compatible with any 40-46mm handle including FEIYU/ZHIYUN/DJI/MOZA Single handle gimbal
30% reduce vertical vibration One tighten knob to tight gimbal，Save time!
Why Choose DF DIGITALFOTO ARES Z Axis Spring Dual Handle?
1.One tighten knob to tight gimbal 2.With anti-scratch rubber mat,your gimbal handle will be protected 3.Compatible with 40-46mm handle like Ronin S/ Zhiyun Crane 2/Crane V2/Crane Plus/Feiyu Series Gimbal 4.With Spring arm design,effectively 30% reduce vertical bounce 5.1/4 threaded hole on handle top for installing LED/Microphone/Monitor etc
6.Handle is connected to the arm by anti-slip gear,which avoid handle moving especially for using Ronin S
7.Weight Bear 1.8-5kg,can meet most gimbal with camera+others
8.Adjust arm tension to achieve best condition for your balance and shooting
9.Anti-slip rubber handhold
10.By changing handhold direction,you can achieve inverted shooting
11.Detachable design ,which make it portable 12.Small raised nails ensure the arms will not fall down 13.Net weight 1kg,ensure not add too much weight for two hand
Standard Configuration Spring Arm with Handle*2 Middle Connect Bridge*1 Round Baseplate*1 Tube for Wireless Controller*1 Screw *1 L Screwdriver*1
Specification:
Compatible:40-46mm handle like Ronin S/ Zhiyun Crane 2/Crane V2/Crane Plus/Feiyu Series Single Handle Gimbal Vibration reduce:30% Weight Load:1.8-5kg
NOTE:Rotate the knob clockwise will increase the tension of the arm; turn the knob counterclockwisel will reduce the tension of the arm
Review
Greg
Jun 15, 2020
Hi guys
I bought the Ares Z to go with my Ronin S but I really need a start/ stop button near my hand as I'm wasting a lot of disk space due to the need to put the gimbal down first and then stop.
Do you have such a device? I use the Pansonic S1.
Lee
Nov 21, 2019
Hi, does the Arez have oil damping? Also do the joints have bearings? I’m deciding between this and the Scotty makes stuff pro glider...
Thanks
Lee
